StatisticsReview of DME Expansion Joints
Expansion Joints > Pump Connectors

551 Series (Standard) - Fixed Flange Pump Connectors

Triangular shaped plate flanges are drilled with 150# or 300# bolting patterns. Pipe stops are used on the tie rods to prevent over compression. Flanges can be furnished in stainless steel and with raised faces when required.

551 Series (Standard) - Fixed Flange Pump Connectors Resources:
551 Series (Standard) - Fixed Flange Pump Connectors Specifications:

552 Series (Standard) - Vanstone Flange Pump Connector
552 Series (Standard) - Vanstone Flange Pump Connector
The use of vanstone flanges with rods does not allow for flange misalignment. The purpose of using this joint is to isolate the flow media from the flanges. This allows for use of carbon steel flanges with stainless steel or inconel. ... 552 Series (Standard) - Vanstone Flange Pump Connector
553 Series (Standard) - Weld End Pump Connectors
553 Series (Standard) - Weld End Pump Connectors
Beveled weld ends allow for a permanent weld into the system. Bellows and weld ends can be furnished in stainless or other alloys and the tie rods and hardware supplied in lower cost carbon steel. ... 553 Series (Standard) - Weld End Pump Connectors